Meteorite logoMeteorite
Back to videos

My PERformer Iteration – Full Build & Why I Changed It

You asked how I built the antenna in the Short. Here’s my POTA PERformer for 20m, 40m and 15m, why I went from two elevated radials to four, and how I tune it for SWR in the field. Greg called my take on his design the “Coyote Ugly POTA PERformer”. Fair enough. I’ve swapped the electrical tape for heat shrink. The Lidl bike stand stays. 😉 Thanks to Joeri Van Dooren (ON6URE) of RF.Guru and to Rudy Severns (N6LF) for the information and advice that helped me put my version of Greg’s design together. I’m keeping Greg’s design simple. I show you the wire I use for the radials, how a bit of bungee cord takes the strain off the Wago connectors, and how Steve’s (G1SJW) excellent radial plates hold the tension at the antenna end. There’s a closer look at the copper battery clamps, the Poly Poles and the telescopic whips from AliExpress and Alpha Antenna. I also explain why I’ve moved away from long wires for portable operating. Fit the 33ft Alpha Antenna whip and I call it the BOTA PERformer. The B/POTA PERformer Super Antenna, if we’re giving it its full title. 😉 If you run a portable vertical, how many elevated radials do you use, and what have you noticed when tuning yours? 00:00 Meet the Coyote Ugly POTA PERformer 01:45 Tuning the radials for SWR in the field 02:30 G1SJW’s radial plates, clamps and connector security 03:25 Poly Poles and a safer field setup 06:25 Double-checking the telescopic whip length 06:52 Why a Lidl bike stand? 08:15 Two elevated radials or four? What changes when tuning 11:20 Why I use a vertical with elevated radials 13:52 Why I’ve moved away from long wires 14:57 Back at base – sorting out the radial tension 15:31 Final thoughts #HamRadio #PortableAntenna #HF #DX #antenna #POTA

Suggested videos