Simple method for rooting clones.

We’re just getting ready to transplant and figured let’s do a quick video on how we got to this point. All you need is ………. 1. Propagation tray with lid/ insert optional but helps keep starting plugs suspended above water. 2. Heat mat with temperature control, set at 77 degrees f. 3. RockWool starter plugs or cubes pre soaked in water Ph at 5.5 4. Rooting powder. (We used Stimroot number 1, depending in the hardness of the stem number 2 can be used as well. 5. Some sort of mild grow light ( clones do not require much light as the don’t have the proper root system to support them and will burn) We use a T5 SunBlaster . With a timer set between 18 to 24 hours. Clean the bottom of each stem , removing any lower branches that will be buried in rockwool, dip in rooting powder and place in pre soaked plugs in propagation tray. We left our lid vents open half but this can vary depending on your R/H. Remove lid once a day for a few minutes to allow fresh air. Foliar spray if needed with a mild spray. We use OpticFoliar Elium. After about 10 days root’s should visible. Good luck on your next clones! #cannabis_cultivate #opticfoliar #lightsonspray #tnbnaturals #teamtnb #divineseedssquad #weedseedsonline #myco4 #terrafirmaplanttechnologies #growdiaries #stepwellsoil