Stop Cutting Crown Molding Until You Make This Jig

#woodworking #wood #woodshop Cutting crown molding on a miter saw can be frustrating - especially when you are trying to get those 45 - degree cuts to fit perfectly. In this video, I show you how to make a simple crown molding jig that holds the molding in the correct position on your miter saw so you can make accurate, repeatable cuts without fighting the set-up every time. I will walk you through how the jig is made, how to set it up, and how to use it to get those perfect 45 degree cuts. It's a simple shop-made jig, but it takes a lot of the guesswork out of cutting crown molding. Thanks for watching, Wes Vidwo reference for inside corners: https://youtu.be/A3hjycqOD2A?si=Orrftfxcg8Ug-ekq Makita Miter Saw https://amzn.to/4j6UhYo This video is not sponsored. Some product links are Amazon and other affiliate links which means if you buy something we'll receive a small commission; with no added charge to you. This helps support my channel so I can continue to make content like this. DISCLAIMER: Woodworking and the use of power and hand tools can be extremely dangerous. You are responsible for understanding the safe use of your tools and techniques. Your safety is YOUR responsibility, I accept NO responsibility or liability for any injuries, accidents, death occurring to you or others if you attempt to do the things that I do or use advice that I give. Chapters: 0:00 Why crown molding cuts go wrong 0:25 The jig that holds crown in position 0:51 How crown sits on the wall 1:19 Building the jig 2:33 Test cut 3:06 Bonus: a 45° assembly jig